Labor Prices on the G54B

These prices do not include parts

Head labor is not listed as we prefer to use new head castings that we sell on our site. If you have any questions please feel free to contact Randy.

Teardown of engine or cylinder heads will be billed at the hourly shop rate.

Crankshaft labor

Clean, magnaflux, check, and polish crankshaft (If grinding is not needed): $80.00

Clean, magnaflux, check, grind rod and rain journals, and polish crankshaft: $220.00

Balance crankshaft: $80.00

Connecting rod labor

Press 4 pistons off/on rods: $60.00 set

Recondition rods (install arp bolts): $120.00 set

Balance rods: $80.00 set

Magnaflux rods, polish beams, shot peen, recondition bearing end and balance: $260.00 set

Magnaflux rods, polish beams, shot peen, recondition bearing end, bore for bushings in pin end, and balance: $360.00 set

Parts not included and are extra.

Cylinder block labor

Degrease and magnaflux block, bore and hone (with torque plate), resurface deck, check main bores, and install new soft plugs: $440.00

Parts not included and are extra.

Assembly

Assemble short block: Install crank, rods, pistons, oil pump and timing components: $320.00

Assemble long block: Short block assembly, cylinder head, rear seal etc. Basically valve cover to oil pan and front pulley to flywheel. This also includes a pressure prime of the oil system: $640.00